![background image](http://html2.mh-extra.com/html/makita/hp331d/hp331d_repair-manual_4295168017.webp)
October 2015
3.1.
REPAIR OF LED CIRCUIT
Use Non-insulated connector and Polyolefin tube (inner diameter: ø4.0mm) as shown below.
When repairing, put terminals in the designated position shown in
. (Cut lead wires if necessary.)
Cut Lead wire in the position shown on the left.
Figure 24
Color index of lead wires' sheath
Black
Red
Figure 25
Cutting position of Red lead wire
(
The same surface as the root of Tab terminal
)
Cutting position of Black lead wire
(
The end face of Polyolefin tube
)
AWG: American wire gauge
LED circuit
Switch
Non-insulated
connector
Non-insulated
connector
Shrink of Polyolefin tube
Shrink of Polyolefin
tube
2mm or more
2mm or more
End face of
Non-insulated
connector
End face of
Polyolefin tube
End face of
Polyolefin tube
AWG24
AWG24
AWG24
AWG24
Resistor
17 / 18