Repair Manual EA6100P / EA6101P
18
Removing the ignition armature
Remove the cover.
Remove the starter. See Chap. 06.
Remove the
ywheel. See Chap. 07.
Unscrew 2 bolts on ignition armature 1.
Pull off cable lug 2 .
Unscrew bolt 3 and remove with cooling air
guide.
Unscrew bolt 4 and remove with cable clamp.
Remove ignition armature with high-voltage
cable, carefully pulling cable lug
2
through the
rubber grommet on the carburettor
oor.
Installing the ignition armature
NOTE:
The high-voltage cable is moulded
onto the ignition system and cannot be
replaced separately.
Insert the ignition armature and screw in the
screws until just before they stop.
Secure the high-voltage cable under the cable
clamp with bolt
4
.
Carefully push cable lug
2
through the rubber
grommet on the carburettor
oor.
Note:
Make sure not to press the rubber
grommet into the carburettor when doing this.
If the grommet gets pushed out, it can be
reinserted from the cylinder side.
Route the high-voltage cable as shown,
engage the cooling air guide tab
5
and secure
it with bolt
3
.
Install the
ywheel.
Insert the setting gauge
6
(chap. 00, Pos. 3)
between the ignition armature and the fylwheel.
Position the
ywheel so that the magnet is
against the armature (gap 0.25 – 0.3 mm).
Press the armature against the gauge towards
the
ywheel and tighten the armature screws
(5
+/-0.5
Nm). Then check the gap again to
make sure it is correct.
Combination switch
Remove the cover and air
lter. Pull off cable
lug
2
.
Unscrew 4
anged nuts
8
(A/F 7).
Unscrew bolts
7
.
Carefully remove the air
lter base from the
rubber buffers
9
and disengage the choke
linkage (arrow).
The combination switch
10
with ground wire
and contact spring can now be removed from
the air
lter base.
Note:
If the gasket on the carburetor or air
ap
is damaged, it must be replaced.
Assemble in reverse order.
07 IGNITION SYSTEM
1
4
3
2
5
6
7
8
9
10