![background image](http://html1.mh-extra.com/html/makita/dtm41/dtm41_technical-information_4128735012.webp)
W
iring diagram
P 1
2
/ 1
2
Fig. D-4
Line filter
Line filter
(if used)
Pass Brush holders’ Lead wires through Line filter. And put Line filter
to the place shown below. (between Brush holder and the inflected
point of Brush holders’ Lead wires)
Inflected point
Fix Switch to Switch box
with this hook.
Pass Lead wires (red, yellow
and black) of Terminal
under Controller.
Do not put
any Lead wires
on this rib.
Lead wires of Brush holder
from Brush holder
Fix Brush holder’s Lead wire
(red) in this Lead wire holder.
Put Brush holder’s Lead wires
(red, black) to the inside of
this Rib.
to Switch
Controller
Battery capacity
warning lamp
Dial section
Wiring in Motor housing
(view from Handle cover side)
Brush holder
Put Closed end splice here.
Switch
Do not put any Lead
wires on Switch.
Put Lead wires (black, white and
red) of Dial section to this groove.
Route Lead wires of Dial section
between these Ribs.
Note
: do not put any Lead wires
other than those wires.
Put the inflect Lead wires
inside of this Rib.
Putting black Lead wire
on red Lead wire, fix them
in this Lead wire holder.