![background image](http://html2.mh-extra.com/html/makita/dhr263/dhr263_technical-information_4111019021.webp)
P 21/ 22
Fig. D-2
Wiring in Housing set (L)
Fig. D-3
To Controller
Rib C
Rib B
Rib C
Rib D
Rib E
Rib A
Route Switch’s lead wires and
Controller’s lead wires between
Ribs A and B.
Note
: Put Black lead wire of Switch
on the other lead wires.
Put Lead wires of Controller
between Ribs E and F.
Groove
Lead wire
holders
Lead wire holder
Rib F
W
iring diagram
Housing set (R) side
Housing set (L) side
Fig. D-4
Line filter
(single hole type)
Line filter
(2 holes type)
Wiring of Brush holder
First, pass Brush holder’s lead wires through Line filter (2 holes type), then
pass the wires through Line filter (single hole type), if Line filters are used.
Fix Brush holder’s lead wires
with these lead wire holders.
Brush holder
Fix Brush holder’s lead wires
with this Lead wire holder.
Compression spring 10
Switch
Put Closed end
splices in here.
Put Line filters to the place here,
if they are used.
Route Switch’s lead wires and
Controller’s lead wires between
Ribs B and D, Ribs B and C.
Line filter
Put Line filter in here.
Brush holder’s Lead wires have to be tightened between
Switch and Lead wire holder by Compression spring 10.
Fix Brush holder’s lead wires with these Lead
wire holders and the groove.
90 degrees
M1 terminal
Handle
set (L) side
Handle
set (R) side
M2 terminal
Wiring to Switch
1. Connect Brush holder’s lead wire (red) to M1 terminal of
Switch and the black one to M2 terminal while keeping
their connectors in 90 degrees as shown below.
2. Bent Connector of Brush holder’s lead
wire (black) toward the red one side.