![background image](http://html1.mh-extra.com/html/makita/dcs460/dcs460_repair-manual_4055999027.webp)
27
3
4
5
MS
KS
1
2
The crankcase magnet side and cylinder side
are held together with six screws
1
.
Two pins
2
ensure proper fitting.
To assemble the ball bearings please note the
following repair instructions
•
Press a ball bearing onto the crankshaft
clutch-side by using an assembling bush.
Press only on the internal ring of the
bearing.
Note:
Put a wedge between the
crankwebs.
•
Heat the crankcase clutch-side up to 150 -
160
0
Celsius (302-320
0
Fahrenheit),
evenly coat the external ring of the ball
bearing with Loctite 601 and slide it
together with the crankshaft in the warm
crankcase without any effort.
Note:
Degrease both ball bearings before
coating the external ring with Loctite 601.
•
Heat the crankcase magneto-side up to
150 -160
0
Celsius (302-320
0
Fahrenheit),
evenly coat the external ring of the ball
bearing with Loctite 601 and slide it in the
warm crankcase without any effort.
•
Assemble the crankcase halves. Put a
wedge between the crankwebs
Always use a new gasket. After bolting the
crankcase sides together, cut off the flash
3
.
Makita is providing crankcases as a spare part
where the ball bearings are already glued into
the crankcase
12 CRANKCASE / CRANKSHAFT