3
ENGLISH (Original instructions)
Explanation of general view
1-1. Lamp
1-2. Speed control screw
1-3. Switch lever
1-4. Higher
1-5. Lower
2-1. Reversing switch lever
3-1. Lamp
3-2. Speed control screw
3-3. Switch lever
3-4. Higher
3-5. Lower
5-1. Chuck key
6-1. Sleeve
6-2. Ring
7-1. Gripping part
7-2. Side grip (handle)
SPECIFICATIONS
Model DA3010
DA3010F
DA3011
DA3011F
Steel
10 mm
10 mm
10 mm
10 mm
Capacities
Wood
25 mm
25 mm
25 mm
25 mm
No load speed (min
-1
)
0 -2,400
0 -2,400
0 -2,400
0 -2,400
Overall length
270 mm
270 mm
270 mm
270 mm
Net weight
1.6 kg
1.6 kg
1.6 kg
1.6 kg
Safety class
/II
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
ENE032-1
Intended use
The tool is intended for drilling in wood, metal and
plastic.
ENF002-1
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
ENG102-3
Noise
The typical A-weighted noise level determined
according to EN60745:
Sound pressure level (L
pA
) : 81 dB (A)
Sound power level (L
WA
) : 92 dB (A)
Uncertainty (K) : 3 dB (A)
Wear ear protection
ENG202-3
Vibration
The vibration total value (tri-axial vector sum)
determined according to EN60745:
Work mode: drilling into metal
Vibration emission (a
h,D
) : 2.5 m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
ENG901-1
•
The declared vibration emission value has been
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
•
The declared vibration emission value may also be
used in a preliminary assessment of exposure.
WARNING:
•
The vibration emission during actual use of the
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
•
Be sure to identify safety measures to protect the
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENH101-13
For European countries only
EC Declaration of Conformity
We Makita Corporation as the responsible manufacturer
declare that the following Makita machine(s):
Designation of Machine:
Angle Drill
Model No./ Type: DA3010,DA3010F,DA3011,DA3011F
are of series production and
Conforms to the following European Directives:
98/37/EC until 28th December 2009 and then with
2006/42/EC from 29th December 2009
And are manufactured in accordance with the following
standards or standardised documents:
EN60745
The technical documentation is kept by our authorised
representative in Europe who is:
Makita International Europe Ltd,
Michigan, Drive, Tongwell,
Milton Keynes, MK15 8JD, England
