R
epair
< 1 > General instruction.
< 2 > Disassembling head bulb section.
< 3> Assembling the head bulb section.
< 4 > Disassembling trigger section.
< 5 > Assembling magazine section.
< 6 > Attaching of driver complete.
< 7 > Repair to stop the leaking air.
Please refer to the following matters on the repair.
< 1> General instruction
I. O rings and O ring part which contacts the sliding parts, have to be coated
with turbine oil (standard equipment), or grease (Isolex NB52), when the machine is
mounted.
II. Please refer to the following parts name.
Exhaust cover
Top cap
Housing
Driver guide
Contact arm
Pusher lever
Magazine
Joint
Inlet cap
Trigger
III. The bolts have to be fastened as follows.
Bolt and Bolt size
Fastening section Fastening torque
Hex socket head bolt M6 x 25
Hex socket head bolt M5 x 30
Hex socket head bolt M8 x 25
Housing - Top cap
Housing - Inlet cap
Housing - Driver guide
9 - 13 Nm
(90 - 130 Kgf.cm)
5 - 7 Nm
(50 - 75 Kgf.cm)
20 - 30 Nm
(200 - 300 Kgf.cm)
IV. Confirm the following matters after mounting of the parts.
* Pusher can slide smoothly.
* Contact arm and trigger can move smoothly.
* Singly by pressing the trigger or contact arm, the machine does not start.
P 2
/
7
