Retaining ring S-38
Cut of retaining
ring S-38
The cut section of retaining ring 38
has to be located within this compass.
< 3 > The cut section of retaining ring 38 has to be located within the following compass.
Arbor press cradle
Rod ø5.5mm or under
40mm
40mm
< 4 >
Removing spur gear 53
Remove two countersunk-head screws and take off bearing box from gear housing complete.
Then follow procedures:
1) remove bearing retainer (left screw),
2) hold bearing box,
3) press arbor from rear of spindle by using a rod, etc. and remove the spindle.
< 5 > Assembling lever 42
Lever 42 has to be so good adjusted and assembled that it can loosen or fasten for depth adjustment
with one action properly.
The instance of the area
in which the depth adjustment
can be done with one action
properly.