R
epair
P 4 / 6
< 1 > Disassembly and assembly of mechanical parts
Disassemble the gear housing cover from the main tool-body by removing the
four tapping screws 4x18.
1) Gear housing cover
1. Remove thrust plate from slider. (See Fig.2-1.) And then, remove slider by unscrewing
countersunk hd.screw M4x10 with a straight T20 torx bit. (See Fig.2-2.)
So, rod can be removed from gear housing cover. (See Fig.2-3.)
Tapping screw 4x18
Gear housing cover
Fig.1
Fig.2-1
2. Attach holder under flat section of rod. See fig. 3.
3. Attach slider to rod, making sure that the flat surface on the slider matches the flat surface on rod. See Fig. 3.
4. Tighten countersunk hd.screw M4x10 used to hold the slider. See fig. 3.
5. Set thrust plate on slider with the folded ends toward the inside of the gear housing cover. See fig. 3.
Countersunk
hd.screw M4x10
Thrust plate
Holder
Slider
Gear housing cover
Gear housing
cover
Gear housing
cover
Fig.2-2
Fig.2-3
Holder
Rod
Flat section of rod
Slider
Countersunk
hd.screw M4x10
Thrust plate
Fig.3
