R
epair
P 5 / 6
< 2 > Assembly of the parts in housing set
1) Balance plates are not symmetric. Assemble the balance plate as shown in Fig.4.
2)Tighten countersunk hd.screw M4x10 with a straight T20 torx bit for mounting pin 8. Note the alignment of pin 8.
The hole in the center of pin 8 must be positioned in the same direction as the tabs on motor bracket as
shown in Fig. 5.
Countersunk hd.screw M4x10
Motor bracket
Pin 8
Hole
Fig. 5
Tab
Tab
This portion has to be faced to the
lever 17 side.
Lever 17
Fig. 4
Fig. 6
3)Assemble the internal parts as shown in Fig.6, and joint crank complete and helical gear 58
by tightening hex socket hd.bolt M4x16
Hex socket
hd.bolt M4x16
Retaining
ring S-8
Needle
bearing 607
Crank shaft
Flat washer 26
Flat washer 6
Flat washer 6
Flat washer 6
Pin 6
Balance plate
Flat washer 6
Pin 6
Pin 5
Flat washer 5
Flat washer 26
Push plate
helical gear 58
