MakerPi K300, User Manual, Page: 9 / 43

9
3.2
Fine tuning
Select a model and wait for the printer to start printing, look at the print platform,
again to see the distance between the nozzle and the platform is probably a piece of
paper, and then start to print debugging platform dedicated auxiliary debugging file, the
adjust.gcode, by looking at the the effect of the first layer to fine-tune platform, print out
the first layer can stop printing, fine-tune and adjustment of the next print.

If the filament spilled out is serrated, the
distance between the platform and the
nozzle is too large, and the filament is
thrown down from the nozzle instead of
sticking tightly.
Turn the nut a little clockwise to make the
platform go up until the phenomenon disappears
and a tight line appears.

If the filament is found to be too thin or not
coherent, it means that the distance between
the nozzle and the platform is too small,
resulting in too small amount of the nozzle.
Turn the nut slightly counterclockwise to
lower the platform until the filament output is full
and smooth.

Adjust well the effect of platform printing
should be
full out of the filament and the
line pressure is flat on the platform.