MakerPi K300, User Manual, Page: 27 / 43

27
5.3
View model

See if the model size can be printed
The size or position of the model
exceeds the scope of the machine's printing,
so the model will appear gray, as shown in
the figure.
Modify the model size or move the
model location as required until the model is
all displayed in yellow.

View model overhang
Overhang usually exists in print model (you can see in Chapter 7),and the following ways
can be used to view overhang.
View mode
：
Located in the upper right corner of the software
：
Normal status view
：
View overhang. Overhang that requires support appears in red.
：
Transparent mode
：
X-ray model
：
View layer by layer, simulate the printing process.