12
www.major-equipment.com
PTO Guard Greasing Intervals
Belt Adjustment
Check belt tension routinely. Remove cover by slackening the retaining bolts. Measure the belt deflection. If the de
-
flection is more than 12mm then adjust
•
Slacken the Idler Mounting Bolt.
•
Tighten the belt using the tensioner
•
Tension until deflection is 12mm
When the drive has been operating under load for a short period (2 to 3 hours) check and ensure that the
belts remain at the appropriate tension.
Belt Removal & Fitting
Check belt tension routinely.
• Remove cover by slackening the retaining bolts
• Loosen Idler Rollers
• Slacken Bolts on front bearing
• Slacken Grub Screws on front & rear bearing
• Remove 6 shaft coupling bolts
• Slide split shaft forward to remove belts & add new ones
• Replace Shaft & tighten coupling bolts
• Tighten bolts on Bearing
• Tighten Grub Screw on front & rear bearings
• Tension Belt
• Tighten Idler Rollers
• Replace Top Cover
Vee belt pulley
cover
Driver pulley
Driver pulley
Idler pulley
Idler pulley
Deflection
Gearbox
pulley
Belt
tensioner
Idler Bolt
Gearbox
pulley
