11
www.major-equipment.com
B
A
Blades must always be timed at 90 degrees to each other as shown below. Failure to do so can cause the
blades to foul and in turn may damage the transmission.
TDR16000 Blade rotations
TDR20000 Blade rotations
Adjusting the Rollers
• Slacken the Height adjuster stop lock nuts (B) and
• Adjust the roller adjuster (A) to obtain the desired cutting height.
• Tightly close the lock nut (B) again to keep the rollers in this position.
NOTE: IT IS IMPORTANT TO HAVE ROLLERS LEVEL AFTER ADJUSTMENT
Blade Rotations
Maintenance
The machine must always be disconnected form the tractor before any cleaning, lubricating and servicing operations
can be carried out. If emergency operations are required whilst the machine is connected to the tractor, switch off the
engine, engage the parking brake and disengage the PTO. Good, regular maintenance and correct use are if the TDR
Rollermower is to remain safe and long lasting.
Only trained and competent personnel should carry out major repairs on the machine. Do not attempt to repair the
machine if you are unsure and contact your local dealer.
PTO Shaft Maintenance
Guard Removal and Yoke End Greasing
1.
Prise back locking tabs
2.
Pull back PTO Guard
3.
Grease points as shown
4.
Push Guard into position
5.
Click into place
6.
Tie check chain
