4
Version: 1.05, 05.10.18
1
Installation
A DMX merger is usually a "permanent operating device" which is, for
example, permanently installed in a data distribution unit. Therefore, the
device does not have a separate power switch.
Plug in the appropriate power outlet (powerCON supply on the rearside
of the device, 100-240V AC, 50/60 Hz). The device performs a self-test
and is then ready for operation.
All of the seven colored LEDs on the front of the device flash briefly from
left to right during the self-test. Then the yellow RDM LED for input B
flashes to indicate the main version number of the firmware currently
loaded in the device, then the sub-number of the software version via the
RDM LED for input C.
At the time of printing this manual the current software version is V1.03.
Therefore the RDM-B flashes one time, the RDM-C three times.
Afterwards
the red „Power“
–
LED shows the operation of the device.
MAJOR…
MERGER
–
>
MERGER
–
DMX
…RDM
>
DMX…RDM
3 - INPUTS
DMX…RDM
VER. 1.3
After a short delay, the unit switches to its standard operating mode.
Summary of Contents for 4001733
Page 1: ...Major DMX Merger 3in1 User Manual...
Page 16: ...16 Version 1 05 05 10 18...
