11
5.10. Mode Button
To select Diode/Continuity/CAP,VAC/Hz/%, °C/°F.
5.11. Data Hold/Flashlight Button
To freeze the LCD meter reading, press the data hold button. The data hold
button is located on the right side of the meter (top button). While data
hold is active, the
HOLD
display icon appears on the LCD. Press the data
hold button again to return to normal operation.
Hold down this button to turn the flashlight ON/OFF.
6. Battery Replacement
1. Remove the one rear head screw
2. Open the battery compartment
3. Replace the required three "AAA" 1.5V Batteries.
4. Re-assemble the meter
5.12. MIN/MAX Button
Press MIN/MAX to enter MIN, MAX Recording mode (manual range only).
Select the proper range before selecting MIN MAX to ensure that the
MIN/MAX reading will not exceed the testing range. Press once to select
MIN, press again to select MAX lastly, press again to release the MIN/MAX
recording function.
5.13. VFD Button
In ACV mode, hold down the mode key to enter the VFD measurement
mode and display VFD. In VFD mode, low-pass filter can reduce the high-
frequency noise when measuring AC voltage. VFD mode is mainly used for
AC voltage measurement of variable frequency drive and frequency
converter.
5.14. REL/ Button
Press REL key to enter the relative value measurement mode, take the
current value as the reference and obtain the relative value. Hold down this
key to turn on the laser in IR-temp measurement mode, and then press
this key to turn off the laser.
results, rub the probe tip along a length of the cord to assure placing the
tip in close proximity to the live conductor.
NOTE:
The detector is designed with high sensitivity. Static electricity or
other sources of energy may randomly trip the sensor. This is
normal operation.
