46
Majestic • MARQ42STIN Installation Manual • 2272-980 Rev. H • 4/21
LOG NUMBER 2 (SRV2272-702):
Place Log #2 as shown. The groove on the bottom of Log #2 should rest on the far left
grate tine as shown in Figure 6. Place the log at the far end of the tine and slide it towards the front until the end of the log
rests in a ridge on the burner as shown in Figure 8. The log must NOT block any burner ports. Note: Logs #2 & # 3 look
very similar. Compare the numbers molded into the bottom of the logs against the list above.
Figure 6. Log #2 from front.
Figure 7. Log #2 close-up from front.
GRATE:
Locate the pilot assembly. The pilot assembly is denoted in this instruction by a black or white arrow (
) on each
photo.
For the purpose of placing logs according to this instruction, begin with the pilot on the left side. From this position,
the close side of the unit will be considered the front and the far side of the unit will be considered the back. Position grate
by locating the four indentations on the bottom refractory. Place grate legs in the indentations as shown in Figure 3.
Figure 2. Burner and grate from front.
Figure 3. Grate leg placement.
PILOT
LOG NUMBER 1 (SRV2272-701):
Locate the pilot assembly. It should be on the left side of the fireplace. Place log #1 into
the grate such that the groove on the bottom sits on the far right grate tine as shown in Figure 4. Push the log forward until the
end of the log butts up against the middle grate tine on the far side. See Figure 5. The log must NOT block any burner ports.
Figure 4. Log #1 from rear.
Figure 5. Log #1 from above, showing end butting into grate tine.
11
11
22
22
