The Majestic Shower Company Limited
One North Place, Edinburgh Way, Harlow Essex
CM20 2SL England,
Tel44 (0) 8448 001 500
Fac44 (0) 1279 635 074
[email protected] www.majesticshowers.com
33
Using the suction glass lifters, replace the glass inline panel into
the horizontal inline profile. Loosely attach the glass-to-glass
bracket faceplate, and adjust the inner apart of the bracket so it
fits snugly between the glass inline and return panels; fully
tighten both faceplates with the Allen key. Check that all panels
sit plumb vertical and level with one another.
34
To protect glass in-line panel B from being
damaged you can slide one of the vertical 1936
seals (1) onto its exposed vertical edge; cut the
seal to size.
1
Door Panel
Fixed Panel
90°
90°
Hinge
packer
Hinge
packer
35
Insert a black rubber hinge packer into the in-line panel hinge
slots as shown. Disassemble the hinges, being careful not to
damage the polished surfaces. Place the hinges and faceplates
either side of the hinge slots in the glass in-line panel, with
gaskets inserted and Allen bolts facing inwards; loosely screw
the hinges and faceplates together.
Use a set square to ensure the hinge sits at 90° to the edge
of the glass.
Door Panel
Fixed Panel
90°
90°
Hinge
packer
Hinge
packer
36
Steps 36-37 require one person to support the glass
door panel at all times, while another person must be
inside the enclosure with faceplates, gaskets and screws. Insert
a black rubber hinge packer in the door hinge slots as shown.
Position the door mounting blocks on the tray or floor. Using the
suction glass lifters, lift the glass door panel onto the mounting
blocks; be careful not to chip the edges of the glass against
each other.
