10002555/0
-33-
33/36/39/43 BDVT
Vermont Castings, Majestic Products.
3. The second terminal of the speed control unit is attached
to either terminal of the thermal sensor.
4. The second terminal of the thermal sensor is connected to
either terminal of the fan motor.
5. The second fan motor terminal is connected to the white
wire of the supply line.
C
B
A
Black
White
Ground
A: SPEED CONTROL
B: TEMPERATURE SENSOR
C: FAN
Method B
(Using the EB-1 Box
.
For instruction on wiring the EB-1 Electrical Junction Box see
the earlier chapter in the Installation section of this manual.
C
ERAMIC
R
EFRACTORY
K
ITS
Ceramic refractory panels are available in kit form for the
BDVT series appliances.
Appliance Model
Kit Name
33BDVT
33BDVTCR
36BDVT
36BDVCR
39BDVT
39BDVCR
43BDVT
43BDVCR
Take care when handling the refractory panels
as they are fragile until held in place and sup-
ported.
Installation,
refer to Figs. 56 & 57
1. Remove the front frame/glass assembly.
2. Remove the logs.
3. Place the lower supports for the side refractory panels on
the base of the rebox. Place each support so that the
slotted hole ts over the forward screw head along the
edge of the base.
4. Lay the angular base panels in place on the oor of the
rebox on either side of the burner housing
5. Loosely attach the top adjustable tabs to the studs located
in the top of the rebox toward the front corners.
6. Place the rear refractory panel in place. Locate the lower
edge of the panel in the ledge formed by the top of the rear
log support bracket.
7. Slide the side refractory panels into place to hold the rear
panel secure. Adjust the top adjustable tabs to hold the
side panel against the rebox wall and secure the tab.
Repeat the procedure on the other side.
8. Replace the logs and frame/glass assembly.
For esthetic purposes we recommend lining up the horizontal
mortar lines.
Side
panel
Lower side supports
Burner Tray
Log Support
Back Panel
Floor
refractory
panel
Adjustable
tab
Floor
refractory
panel
Adjustable
tab
Side
panel
Firebox
back
panel
Rear
log
support
Rear
refractory
panel
Rear
panel
support
brackets
F
RONT
W
INDOW
S
CREEN
An optional front window screen is available for the 36BDVT,
39BDVT and 43BDVT.
Appliance Model
Kit Name
36BDVT
36BDVTKS
39BDVT
39BDVTKS
43BDVT
43BDVTKS
Installation,
refer Fig. 58
DO NOT ATTEMPT to install or remove the
screen while the appliance is hot.
Either remove the top and bottom brass window trims or
take care not to scratch them during the installation of the
screen kit.
1. Slide the tabs on the top edge of the window screen
assembly up into the slots in the underside of the top rail
of the window frame.
2. With the tabs in the slots place the screen down against
the glass.
3. Slide the screen down the glass until the bottom edge of
the screen sits in the gap between the bottom rail of the
window frame and the window glass.
To remove the screen for glass cleaning reverse the installa-
tion procedure.
Fig. 55
Fig. 56
Fig. 57
