Majestic 33BDVR, Installation Instructions And Homeowner'S Manual

Page: 22 / 40

22
BDVR Series Direct Vent Gas Fireplace
10003357
Unpack the logs from packaging and remove each log
from its wrapping materials.
The logs are fragile and should be
handled with care. Keep the packaging
material out of the reach of children and
dispose of the material in a safe manner.
The individual logs can be easily identified by the
numbers cast on the underside of each log.
Installation of Logs, Lava Rock & Ember Material
Log Identification Chart
Location 33BDVR 36BDVR 39BDVR 43BDVR
Front Left -- BB11 BC11 BD12
Front Right BA9 BB12 -- BD14
Rear -- BB13 -- BD11
Top Right -- -- BC12 --
Rear Left BA7 -- BC10 --
Rear Fr Rt BA8 -- BC13 --
Top Center -- -- -- BD13
33BDVR
Refer to Figure 38
1. Remove the top louvre assembly.
2. Remove the window frame assembly.
3. Fit the rear front right log (BA8) onto the rear log
support. Ensure the rear right end of the log is
located against the bracket bending up on the right
side of the support.
4. Fit the rear left log (BA7) onto the rear support.
Ensure the rear right end of the log is located
against bracket bending up on the right side of the
support.
5. Place the right rear log (BA9) in position by resting
the hole under the center of this log located over the
knob on the branch of the rear front right log, and
the front end of this log will also set against the
back wall of the deflector.
6. Scatter the ember material over the front area of the
burner housing assembly. (Fig. 38) Do not pack this
material tightly, separate it when unpacked and
keep it in a loose condition.
7. Scatter the lava rock material around the firebox
base.
Do not place any of the lava rock material
on the burner housing.
36BDVR
Refer to Figure 39
1. Remove the top louvre assembly.
2. Remove the window frame assembly.
3. Fit the rear log (BB13) onto the rear log support.
Ensure the log’s bottom holes are located on the
two pins of the support.
4. Place the front left log (BB11) onto the left cut out of
the rear log while the front of this log will set against
the back wall of the front deflector.
5. Place the front right log (BB12) in position by resting
the hole under the center of this log located over the
knob on the center rear log, and the front end of this
log will also set against the back wall of the
deflector.
6. Scatter the ember material over the front area of the
burner housing assembly. (Fig. 39) Do not pack this
material tightly, separate it when unpacked and
keep it in a loose condition.
7. Scatter the lava rock material around the firebox base.
Do not place any of the lava rock
material on the burner housing
assembly.
33BDVR
BA7
BA8
BA9
Embers
LG268
Fig. 38 33BDVR log placement.
BB13
Embers
BB11
BB12
36BDVR
LG267
Fig. 39 36BDVR log placement.