MIGE3028-4GF Serial Rack Mounted Industrial Ethernet Switch
- 6 -
SFP modules hot Swap step showed as fig 2-4.
Figure 2–4 SFP module hot swap
Hot plugging steps:
Take the end of the PCB cheat.
The gold finger end is turned back to the PCB board and inserted into the
metal shielding cage of the SFP. When the sound of the cymbal is heard, the
device has been inserted into the position, and then the SFP is inserted and
pulled, and placed in the normal position parallel to the interface.
Hot extraction step:
First, the SFP plug handle is pulled down and perpendicular to the
interface. At this time, the optical device should be disconnected from the hook
of the SPF shielding cage.
The SFP module is pulled parallel.
Power input terminal
This series switches use standard dual AC220V power, with 5.08mm pitch
power input terminal connected, as shown in FIG.2-5.Input voltage
range:AC85~265V(frequency:47~63Hz) orDC110~370V.The power
consumption of the whole machine is less than 40W.
Figure2 -5Power input terminal schematic
