Figure 7
Figure 5
A
Figure 6
D
7. Install Push Button (D)
• Unscrew the tightening nut, which is attached to the button
mechanism.
• Insert the push button body through the tank lid hole. Tighten with
the large nut supplied. (Figure 6)
• Adjust thread rods using locknuts so that the rods are positioned
just over and slightly touching the top of the half flush and full flush
mechanism.
• Note that the half flush is the green tab in the rear and the full flush
is the white tab in front. (Figure 7)
• Note: All toilets come preset and do not need to be adjusted.
6.
Install Tank (A), (Figure 5)
• Place rubber washer (II) onto bolt (JJ). Insert bolt (JJ)
with washers through hole inside the tank (A).
• Place metal washer (HH) followed by hex nut (KK) onto
bolt (JJ) protruding from bottom of tank (A). Tighten
hex nut (KK) to create a proper and secure seal.
• Attach rubber sealing gasket (LL) to center drain hole
under tank (A).
• Gently place tank (A) on toilet bowl (B) with bolts (JJ)
protruding out underneath.
• Place metal washer (HH) followed by hex nut (KK)
onto the protruding bolt (JJ).
• Tighten hex nut (KK) enough so that the tank (A) sits
flat on the toilet bowl (B).
• Make sure the toilet tank (A) is parallel to the wall and
straight on the toilet bowl (B).
• CAUTION: DO NOT OVERTIGHTEN NUTS. SEVERE
DAMAGE MAY OCCUR.
ASSEMBLY INSTRUCTIONS
