Maico EVR 31, Mounting And Operating Instructions

Page: 14 / 28

14
Electrical connection
DANGER
Danger to life from electric
shock
 Switch the mains fuse off.
CAUTION
Unit damage in the case of
short-circuits

Cut off and insulate any
unnecessary cable cores.
CAUTION
Danger of short-circuits
through incorrect feeding of
the power cable into the
housing.
 Feed the power cable
professionally through the
cable grommet and make sure
there is tension relief. See
printed cable run.
 Locate both cable grommets [5] in the
connecting flange.

Feed the power cable through the open
cable grommet.
 Connect the power cable to the connection
terminal socket [9] as shown in the wiring
diagram on Page 25.
Internal housing installation
see also Figure A, bottom right
CAUTION
Danger of short-circuits and
unit damage with wrong
polarity
 Make sure the polarity is
correct, see labels A and B.
NOTICE
Damage to the contact holder
caused by tearing or pulling
on the plug cable

Always hold the internal
housing near the connecting
flange to avoid pulling tension
at plug connection.
 Plug the connection terminal plug [12] on to
the connection terminal socket [9].
 Push the internal housing parallel onto the
connecting flange as shown bottom right in
Figure A.
The internal housing must clip into
the upper locking hooks [3.1].
Don’t trap the cables.
 Close both catches [13] with a screwdriver.
 Switch the mains fuse on.
 Carry out a function test.
i
GB