11
To use the gage in the other probe positions — 90°, 180° or 270°, the PocketSurf
unit and probe must be carefully aligned to the workpiece surface to be measured.
The base of the PocketSurf unit must be at approximately the
same elevation
(within ±.100"/±2,5mm) as the surface being measured, and the axis of probe
traverse must be
parallel
to the surface being measured.
With the probe positioned on the workpiece surface to be measured, carefully
adjust
the gage and workpiece setup so that the black, scribed Reference Line on
the Probe Mounting Block is
parallel
to the bottom of the PocketSurf housing and
parallel to the work surface. This ensures that the probe skid and stylus are flush on
the surface, even though (except for the Small Bore Probes) the probe body will be at
an angle to the surface.
Other Probe Positions
Other Probe Positions
Other Probe Positions
Other Probe Positions
Other Probe Positions
Parallel
Reference Line
Reference Line
Within ±.100"/±2.5mm
Within ±.100"/±2.5mm
