10
The Pocket Surf gage can be hand held or placed on a surface in any attitude;
it will operate in virtually any position — horizontally, vertically, at any angle in
between, even upside-down. In the “Closed” probe position, the gage can
measure flat surfaces or cylindrical surfaces (O.D.’s) down to
¼"/6,35mm in diameter. However, the workpiece or surface to
be measured must be at least 3½"/89mm long so that
it will span the two “V’s” on the bottom of the
Pocket Surf unit and rest securely
against them.
“Closed” Position
“Closed” Position
“Closed” Position
“Closed” Position
“Closed” Position
For workpieces or surfaces less than 3½"/89mm long (too
short to span the “V’s”), use of EAS-2584 Bottom Plate (an
optional accessory) is recommended.
“Closed” Position
