In case the portafi lter rest does not fi t your espresso
machine’s portafi lter, please contact your local
dealer. He will arrange a different portafi lter rest.
5.4.2
Push the port-a-fi lter of your espresso machine onto the
start/stop switch between the port-a-fi lter mounting and the
rest.
5.4.4
Now push up the port-a-fi lter rest until the port-a-fi lter
holds on its own. Refasten the screws.
6. Operation
Only use the K30 ES / K30 Vario espresso grinder for whole roasted
coffee beans. See chapter 1.3.
Observe the safety instructions under 1.2!
The max. permissible operating cycle for 200-230V and 240V is
4 sec. ON and 16 sec. OFF, i.e. three double shots per minute. For
115V the max. permissible operating cycle is 6 sec. ON and 60 sec.
OFF. Do not exceed the maximum allowable continuous grinding
time of 20 min. Afterwards, allow the grinder to cool down before
the next operation.
6.1 Handling the grinder
Proper operation necessitates the steps described in the following:
5.3 Electrical installation
Protect your device with separate pre-fuses (not
included in the scope of delivery) according to
the information provided under Point 2 “Techni-
cal data”.
Make sure that the pre-fuse is not overloaded by
other devices (e.g. fan heaters, deep freezers).
Check whether the main voltage and frequen-
cy correspond to the information on the rating
plate.
Insert the plug into the corresponding grounded outlet.
5.4 Adjustment of the port-a-fi lter rest
The grinder is designed so that all different port-a-fi lters from
various espresso machines fi t into the rest (pos.14) for hands-free
grinding operation
.
Proceed as follows for adjusting the port-a-fi lter rest:
5.4.1
Keep the grinder switched off. Slightly loosen the allen
screws (pos. 15) with the provided allen wrench size 3mm and
pull down the port-a-fi lter rest (pos. 14).
G A S T R O N O M I E M Ü H L E N | H O R E C A G R I N D E R
8
