Mahlkonig Guatemala, Instruction Manual

Page: 20 / 28

Cleaning the surface underneath the grinder
1. Switch o ff the grinder (On/O ff switch (13) to posi on 0 ) and remove the
power plug from the socket.
2. Li the grinder by its casing with both hands and place it on another
surface that is clean.
3. Use a damp cloth to clean the surface on which the grinder is used and
then dry the surface.
The surface must be dry and free from oil and grease.
4. Use a damp cloth to clean the bo om of the grinder by carefully pping
it to the side and then dry the bo om.
The bo om must be dry and free from oil and grease.
5. Place the grinder back onto the cleaned surface.
Cleaning the casing
1. Switch o ff the grinder (On/O ff switch (13) to posi on 0 ) and remove the
power plug from the socket.
2. Clean the following parts of the grinder with a brush:
• Spout (6) ,
• Spout chute (11) ,
• Bag clamp (15) ,
• Bag clamp lever (3) ,
• Table (5) ,
• Vibra ng basket (10) ,
• Vibra ng basket holder (19) , table mount (16) , adjus ng screw (17)
for the table, adjus ng screws (18) for the vibra ng basket (le and
right).
3. Remove the collec ng tray (4) by li ing it out of the casing recess.
Wipe the casing and the collec ng tray with a damp cloth as necessary,
but at least once a week.
4. Clean the mechanism of the bag clamp (3, 15) with a hand-held vacuum
cleaner.
5. Clean the power cable outlet (14, Fig. H) at the rear of the casing using a
brush and a hand-held vacuum cleaner.
COFFEE GRINDER
20