CAJ-25LP | 9 | en
Operation
7.2
Lowering a vehicle
1. Make sure the vehicle load does not exceed the rated
capacity of the jack (50,000 lbs. / 22,680 kg.)
2. Inspect the jack for signs of wear or damage (see
“Inspection Instructions” in Section 8). The jack should
be immediately removed from service if you detect any
abnormal conditions or signs of damage that suggest
the jack will not work properly or safely
— When in
doubt, don’t use the jack!
3. Transport the jack to the work area by wheeling it. You
can push or pull the jack. Wheel the jack across smooth
surfaces only.
4. Close the release knob by rotating clockwise and
actuate the control valve to raise the vehicle off the
vehicle support stands.
5. Carefully remove the vehicle support stands from
beneath the vehicle and place them away from the work
area.
6. Slowly turn the release knob counterclockwise to lower
the vehicle to the floor gently. The ram will fully retract
by leaving the air supply connected and the release
valve open. The ram will fully retract even under no-load
conditions.
7. Lower the jack completely and move the jack and
chocks away from the work area.
