MAHLE ACX2150, Operation Manual

Page: 7 / 36

| ACX2180H | 7 en

The ACX2180H must always be transported in its operating
position. Never lay the ACX2180H on its side, as oil could
then escape from the vacuum pump or the built in compressor
could be damaged. There are no additional safety systems
for protecting the ACX2180H against damage resulting from
natural catastrophes.

We recommend calibrating the scales at least once per year.
Contact customer service for calibration of the scales.

The ACX2180H must be subjected to regular maintenance by
service personnel or authorized agents to ensure the safety of
the unit.

Disconnect power before performing any maintenance or
service to unit.

Never perform any maintenance work which is not expressly
recommended in this manual. Contact customer service if
components have to be replaced other than in the course of
maintenance work.

The ACX2180H must be connected to a properly grounded
electrical connection.

If there is damage to the ACX2180H, terminate usage
immediately and contact customer service.

The service hoses and service quick-release couplings must be
regularly checked for wear and replaced if damaged.

The ACX2180H must be operated in an environment
corresponding to the directive BGR 157 with respect to the
exchange of air.

Observe local laws or directives as to ensure the safety of the
pressurized device.

Follow the pertinent legal regulations or directives to ensure
safe handling of pressurized devices.

For safety reasons it is advisable to use a residual current
operated circuit breaker (rccb) with the following
specifications:
Parameters
Rated voltage 110 VAC ± 10%
Rated frequency 50/60Hz
Rated current 10A
Rated tripping current 30mA
Tripping switch C

Ne ver remove any components from inside the ACX2180H
except for maintenance or repair purposes.

Avoid using an extension cord with the unit. If necessary,
use a good condition (three wire grounded, #14AWG or
larger) extension cord of the shortest possible length. In
addition, the current drawn by all devices connected to the
wall socket must not exceed 15A total.