7
ASSEMBLY
STEP 1
SNOWBLOWER PREPARATION
NOTE: This step requires two people.
Wrap the rotation ring (item 1) (groove inside) around
the edge of the discharge chute (item 2) as shown.
Place the chute (item 3) (opening facing forward) over
the rotation ring.
IMPORTANT
: The ring must be inside the base of the
chute. It is the chute that will hold the rotation ring in
place.
On the right side of snowblower, install the grooved
rotation ring (item 4) under the chute as shown.
Secure the chute and rotation ring in place with six
hex bolts
1/4’’
x 1
1/4’’
(item 5) and nuts as shown.
Do not tighten too firmly.
On the left side of the snowblower, install the other
half of rotation ring (item 6) under the chute as
shown.
Secure the chute and rotation ring in place with three
hex bolts
1/4’’
x 1
1/4’’
(item 7) and nuts (as shown).
Do not tighten the nuts too firmly.
(Nuts that are too tight might prevent the chute from
rotating side to side. Only a slight pressure is
necessary).
Install the rotation ring
Adjust the hydraulic motor (item 1) by loosening the
three nuts on the carriage bolts (item 2) that hold the
hydraulic motor in place. Do not remove the nuts.
Slide the motor towards the chute (item 3) as shown
(the grooves on the motor
’
s sprocket must match
those of the rotation ring). Adjust and retighten the
nuts. Tighten firmly.
Install the sprocket guard (item 4) as shown and
secure in place with two
1/4’’
x
1/2’’
bolts (item 5).
Install the rotation ring & chute
Install the sprocket guard
WARNING
Operate only when all the guards are in place.
