MMS 2000P
MMS 2400
MMS 3000
23
EN
4.3.7. JOB Mode
Change from synergic mode
to JOB mode
J
O
B
is made by short press of the JOB button . After entered the Job
mode, number of actual job is shown in the Material thickness / JOB window.
There are 100 jobs available: J00
– J99. By Turning main encoder can
be chosen required job number.
While in JOB mode, there are no set up and adjustments available
except the JOB number and welding mode. If adjustment is required,
JOB editing must be activated
– see following section
To quit from JOB mode press JOB button
JOB
again.
4.3.8. Editing / saving the JOB
While working in synergic mode
, by long pressing the JOB button
JOB
actual set up
can be stored. After long pressing of JOB button, number of job starts to flash. This number
can be changed by encoder rotation, after desired job number is set by pressing the encoder
button actual set up is saved under this job number.
To edit actual job, set job number to change, by long pressing the JOB button
JOB
the
material thickness start to flesh and any change of any parameter can be made. After
changes are made, by short press of encoder button will be stored.
JOB
