8
BA322301-en
devices in combination with the lift must be approved by the manufacturer.
•
Do not use the lift for transporting persons.
•
Lifts with support arms or wheel-free jack: when raising the lift, all support
points at the vehicle body must be engaged at the same time.
•
Lifts with support arms or swing arm jack: use one additional extender or one
support block only for each support point.
•
Lifts with support arms or swing arm jack: check arm restraints for secure en-
gagement as soon as support arms contact vehicle lift points.
•
Lifts with wheel-free jack: secure engagement of the vehicle must be ensured
by using appropriate means (e.g. lashing straps).
•
After raising the vehicle briefly, stop and check the lift supports for secure con-
tact.
•
Make sure the vehicle doors are closed during raising and lowering cycles.
•
Make sure the parking brake is applied during raising and lowering cycles.
•
Closely watch lift and vehicle during raising and lowering cycles.
•
Do not allow anyone to stay in lift area during raising and lowering cycles.
•
Lifts with support arms or wheel-free jack: after setting down the vehicle, check
the lift supports for secure contact before raising the vehicle again.
•
Axle lift (if present): observe the installation instructions. Use both hands when
moving the axle lift. The axle lift must be in park position during raising and low-
ering cycles.
•
Axle lift (if present): the vehicle must be additionally secured against rolling off
while one axle is in a raised position.
•
Do not allow anyone to climb up the lift or the raised vehicle.
•
Before leaving the lift, fully lower the vehicle or secure it against accidental low-
ering.
•
Keep lift and vehicle free of tools and parts.
•
Keep the lift and lift area clean. Risk of slippage on oily floors!
•
The main switch serves as emergency stop switch. In case of emergency turn it
to “0”.
•
Protect the lift against unauthorized usage by padlocking the main switch.
•
Protect all parts of the electrical equipment from humidity.
•
Use caution with operating vehicle engines. Danger of poisoning!
•
When removing heavy vehicle components, the centre of gravity can change. In
such circumstances appropriate action must be taken as required.
•
Residual risk: Tripping over runways of surface mounted lifts, tripping over
tools.
Pos: 22 /-----Format-----/Seitenumbruch @ 0\mod_1134403577687_0.docx @ 1277 @ @ 1
