ii
The contents of this manual are subject to change without prior notice. Should revisions be necessary, updates to all
Magtrol User’s Manuals can be found at Magtrol’s web site at
www.magtrol.com/support/manuals.htm
.
Please compare the date of this manual with the revision date on the web site, then refer to the manual’s Table of
Revisions for any changes/updates that have been made since this edition.
REVISION DATE
Prelimimary Manual, revision I – October 2012
TABLE OF REVISIONS
Revisions To This Manual
Date
Edition
Change
Section(s)
10/11/12 Preliminary
manual, rev. I
The OV and OS command added to section 5.2.1. The CALS and
FREQ# command added to section 5.3
5.2.1, 5.3
10/02/12 Preliminary
manual, rev. H
Code UD = 6 added for TF 3xx series Torque Flange Sensors.
5.2.2, 5.2.2.1
09/17/12 Preliminary
manual, rev. G
Calibration procedure updated.
6.3, 6.3.1,
6.3.2, 6.3.3
09/21/10 Preliminary
manual, rev. F
TF models 205 and 209 added
5.2.2.1
05/14/10 Preliminary
manual, rev. E
TF models 205 and 209 added
4.1.2
02/10/09 Preliminary
manual, rev. D
Pin 2 of RS-232C connector changed from “RX” to “TX”.
Pin 3 of RS-232C connector changed from “TX” to “RX”.
2.2.1, 5.1
12/18/08 Preliminary
manual, rev. C
Deca-Newton meters (daN·m) added to torque units selection
4.1.3, 5.2.2
12/18/08 Preliminary
manual, rev. C
TF 220 added to model selection
4.1.2, 5.2.2.1
08/24/07 Preliminary
manual, rev. B
*IDN? command added
5.2.1
08/24/07 Preliminary
manual, rev. B
OD command data string changed
5.2.1
08/24/07 Preliminary
manual, rev. B
TM 301 and 302 added to model selection/codes
4.1.2, 5.2.2.1
07/20/06 Preliminary
manual, rev. A
Speed Output BNC changed to 3.3 VHC pulse (buffered from
transducer)
1.3
07/20/06 Preliminary
manual, rev. A
To accommodate Magtrol Dial Weight Dynamometers:
Pin 7 of TRANSDUCER connector changed from “N/C” to “5 V OUT”.
Pin 8 of TRANSDUCER connector changed from “N/C” to “5 V COM”.
2.2.1