7
SETUP
3. Installation/Configuration
Note:
Before installing the 3410, you should become familiar with the
front and rear panels, as outlined in
Chapter 2–Controls
.
3.1
POWERING UP THE 3410
Note:
To reduce the risk of electric shock, the case of the 3410 is earth
grounded.
3.1.1
L
ine
V
oLtage
The 3410 will operate with either of the following power sources without any modifications:
• 120 V 50/60 Hz
• 240 V 50/60 Hz
3.1.2
S
eLf
-t
eSt
Note:
To make sure that the 3410 is operational, a Magtrol torque sensor
must be installed and connected to the 3410.
1. Connect the 3410 to the torque transducer using a 14-pin to 6-pin signal cable.
Figure 3–1 Cable and Connection Diagrams