5 - Configuration
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Installation and Operation Manual
Page 32 of 60 (
D998200129-10
)
16)
Press the device’s power button for two seconds to turn it off, and use the function keys to select
Yes
. The device will reboot because USB is attached.
17)
Change the Active Connection to 802.11 Wireless (see section
).
18)
The screen will show a flashing wireless network icon at the top (see section
19)
Press
Left function key
,
7
,
8
,
3
,
Right function key
.
20)
The device will show a page about the 802.11 wireless connection. Write down the
IP Address
and
press the
Cancel
key to close the screen.
21)
The device is now configured for hosts to connect to it using the wireless access point.
22)
Test the connection between the device and the host:
a)
If the host software is already configured, follow the steps in section
