3 - Installation
DynaPro| Secure Cryptographic Device for PIN and Data Entry | Installation and Operation Manual
Page 22 of 40 (
D99875586-41
)
3.5
How to Install and Remove the Privacy Shield
To install the privacy shield, follow these steps:
1)
Place the clips of the open end of the Privacy Shield into the openings located just above the contact
card slot, as shown in
2)
Pivot the shield down, locking the three clips into the holes located just above the function buttons.
Figure 3-3 - Installing the Privacy Shield
To remove the privacy shield, follow these steps:
1)
Slowly lift the edge of the privacy shield closest to DynaPro’s display.
2)
Pivot the shield up to a 45 degree angle.
3)
Remove the shield.
