MCC-35
12
5.2 Quick Start
1. Turn on machine.
2. Press Mode Key to recall a template or create a template referred to
5.3.4
according to the printing job.
3. Put paper in the tray, adjust the side guides according to the paper properly,
referred to
5.4.1
.
4. Fit tray and card collector as per finished piece.
5. Press Test Key to run one for checking if feeding is skewed and cards are
good.
6. If skewed, adjust the side guides referred to
5.4.2
. If feeding is ok, but
finished pieces are not ok.
7. Use the compensation function to make cards ok referred to
7.6
.
8. All above are finished, input the preset qty value (such as 5) and press Start
to run the job.
9. Keep feeding by hand and machine will stop after running 5 sheets or just
press Stop key to stop machine.
10. Take the cards out from the card collector.
Summary of Contents for MCC-35
