3
LIST OF CONTENTS
For your convenience this band saw is shipped from the factory partially assembled and requires only minimal assembly and
set up. In addition to your new
BAND SAW (A)
the carton should contain the following:
•
(A) BAND SAW
•
(B) MITRE GAUGE
•
(C) BASE CABINET
•
(D) TABLE AND TRUNNIONS
•
(E) TABLE-TILT BRACKET
•
(F) TENSION LEVER
•
(G) DUST PORT
•
(H) HARDWARE BAG
including two power cord hooks,
two lock knobs, four hex head bolts, eight flat washers,
four hex nuts, two screws, one long hex head bolt,
one 5 mm Allen wrench, 3 mm Allen wrench, 10 mm
combination wrench
ADDITIONAL REQUIREMENTS FOR SET UP
• Extra person to help lift
• Phillips screwdriver
• Flat head screwdriver
• 12 mm open-end wrench
• 12 mm hex socket
• 10 mm hex socket
• Feeler gauge set
• Combination square
ASSEMBLY INSTRUCTIONS
MAGNUM INDUSTRIAL MI-91350 DELUXE 14" WOOD BAND SAW
• Before you assemble your band saw, review the parts breakdown and keep it ready for reference.
• Start by removing the parts from the packaging.
• Carefully check the packaging for small pieces before you continue.
• Lay out the parts on a large, clear and unobstructed area and ensure that all parts are accounted for.
• If you have any questions or require further information, please contact the KMS Tools Service Department at 604.395.4134
or email [email protected]
WARNING!
Serious personal injury could occur if you
connect the saw to the power source before
you have completed the installation and
assembly steps!
FIGURE 3: CONTENTS
3
Summary of Contents for MI-91350
Page 1: ...MODEL NO MI 91350 OPERATING MANUAL ...
Page 18: ...MI 91350 ASSEMBLY ...
Page 19: ...MI 91350 ASSEMBLY ...
