Magnum Industrial MI-51100A, Operating Manual

Page: 30 / 43

29
13. Do not push or hold onto the free or cut-off side of the workpiece.
14. Continue pushing the workpiece until it is clear of the blade. Do not overload the motor by forcing the
workpiece into the blade.
15. When cut is complete, turn saw off. Wait for blade to come to a complete stop before removing
workpiece from table.
Fig.28
BEVEL RIPPING
Bevel ripping is the same as ripping except the bevel angle (A) is set to an angle other than 0. When making
a bevel rip cut, place the fence on the right side of the blade so that the blade is tilted away from the fence
and hands.
Fig.29
CROSSCUTTING
1. Remove rip fence.
2. Make sure bevel angle is set to 0°.
3. Set blade to correct height for workpiece.
4. Place miter gauge in either miter slot.
5. Set miter gauge to 90° and tighten miter gauge lock knob
6.
Hands must remain at least 6 inches from blade throughout entire cut. If workpiece is too small to keep
hands at least 6 inches away from the blade, select a larger workpiece.
7. Make sure the workpiece is clear of the blade - at least 1 inch or 25mm away - before starting the saw.