Magnum Industrial MI-51100A, Operating Manual

Page: 21 / 43

20
CHECKING SQUARENESS OF EXTENSION TABLES SAW TABLE
See Figure 9 and 10.
The extension wing should be checked for squatness to the saw table for smooth operation of the
rip fence and rails.
Place a square on the saw table, with the short end up and check .The long end of the square
should extend across one of the extension wing. If the extension wing, proceed as follow

Loosen the two hex nuts (one for each rail) securing the front and rear rails to the extension
wing. Do not loosen hex nuts securing rails to saw table
 Raise or lower extension wing until it is square with the saw table.
 Tighten hex nuts securely.

Check extension table on opposite side of blade.
Repeat the above procedure until it reaches the Squares. (Fig.10)
Fig.10
Fig.9
ASSEMBLE AND ADJUSTMENTS