Magnum Industrial MI-51100A, Operating Manual

Page: 22 / 43

21
K
J
I
BLADE NUT
WASHER
BLADE
BLADE
ARBOR SHAFT
CHANGING THE SAW BLADE.
Attention: left hand thread.
Remove the arbor nut (J) and flange (I).
Place saw blade on arbor shaft making sure teeth point down at the front of the saw.
Reinstall flange and arbor nut and securely tighten.
Remove the locking pin (K).
Check the correct position of the raving knife in regards to the saw blade (see the next section).
Reinstall the saw guard.
Fig.11-1 Fig.11-2
MOUNTING AND ADJUST THE RIVING KNIFE:
The supplied riving knife must always be used.
The riving knife has to be adjusted in such a way that over its entire length the gap between saw
blade and riving knife does not exceed min.3 mm and max.8 mm (Fig 12).
Fig.12
ASSEMBLE AND ADJUSTMENTS