Magnum Industrial MI-51100A, Operating Manual

Page: 26 / 43

25
DUST COLLECTING TUBE SIZE AND INSTALLATION POSITION
The dust collecting hole is located at the rear of the frame and is 4 inches in size. It must be locked
and not detached during installation.
After the machine has been used, remove the dust collecting tube, clean the wood chips in the dust
collecting hole, and keep it clean.
Fig.24
See Figure 25.
You can set the miter gauge at 0
o
and plus or
minus 45
o
with the miter gauge stop pin and
adjustable stop screws.
Note: The miter gauge provides close accuracy
in angled cuts. For very close tolerances,
test cuts are recommended.
 Loosen knob and pull out on stop pin to rotate
miter gauge base past stop screws.
 Loosen the lock nut of the 0
o
stop screw at
the stop pin with a 8mm wrench.
 Place a 90
o
square against the miter gauge
rod and the miter gauge base.

If the rod is not square, loosen the knob,
adjust the rod, and tighten the knob.
 Adjust the 0
o
stop screw until it rests against
the stop pin.

Adjust the plus and minus 45
o
stop screws
using a 45
o
triangle and the steps above.
Fig.25
ADJUSTING THE MITER GAUGE