©2013 Magnum Energy, Inc.
1
1.0 Introduction
1.0 Introduction
The ME-MR remote control allows you to monitor and customize the basic
operating parameters of your Magnum inverter/charger. This remote can be
used on all Magnum inverter/charger models.
Info:
The ME-MR remote control has minimal settings available
from its menu. Careful consideration should be given to choosing
this remote over the full featured ME-RC when customizing the
inverter/charger for your particular system.
The ME-MR25 comes standard with a 25-foot, 4-conductor telephone cable
and includes non-volatile memory (preserves adjustable settings, even if
power to the remote or inverter is removed).
Info:
This manual is for the ME-MR remote with revision 1.1 or
higher. See
Section 3.2.12 (TECH Menu) on page 16 for information
on how to determine your revision level.
LCD
Display
LED
Indicators
SAVE/
HOLD
Button
ON/OFF
/CHANGE Button
MENU/HOME
Button
The ME-MR is equipped with the following features:
•
LED Indicators
–
The at-a-glance LEDs provide a quick indication of
the inverter’s status, or noti
fi
es you if a fault is present.
•
LCD Display
–
The LCD display is a 8 x 2 line (16 characters total),
alphanumeric display used for setting up the inverter/charger operation, as
well as viewing current status or fault messages.
•
ON/OFF or CHANGE Button
–
This button enables you to turn the
inverter on and off, and also serves as a “change” button to navigate through
the available settings for each menu.
•
MENU or HOME Button
–
This button accesses the remote’s menus.
You can also return directly to the scrolling Home screens by pressing and
holding this button for 2 seconds. See also Figure 3-1.
•
SAVE or HOLD Button
–
This button serves as a “save” button to
retain your settings. This button also is used as a “hold” button to stop the
Home screens from scrolling (press and hold the button for 2 seconds).
Figure 1-1, Front Panel Features
