Magnetic Racing 013, How To Assemble

Page: 4 / 43

We now glue on the next floor to the underside. Before gluing, double
check that all the holes are free of laser cut debris. Pay particular
attention to the small square holes around the edge. If you don't do
this they may be difficult to remove once you have glued on the part.
There are etched lines on this part which align perfectly to the edges
of the other floor. When applying glue do this around the edges
inside the etched lines and also in the centre. do not go near the slots
as we do not want glue to seep into them. Press the model together
on a flat surface. If you want to work a little slower you can switch to
wood glue here and press the model together with a weight on the
top of the until the glue goes off. This can give you extra time to slide
the faces around a little to get them aligned more accurately.Pay
particular attention to the stair landing which sticks off the rear edge.
The better you get this, the easier the stairs will be to attach later.
Turn the model over and orientate it a shown in the image below.
Glue on the front wall. Once again use another square edged part of
the kit to ensure it is glued upright.