Magnetic Racing 013, How To Assemble, Page: 34 / 43

outwards on both rails. Do a dry assembly first and check everything
goes together. Ensure that the rail is glued vertical. also push it back
against the sides of the floor so it sits into the corner.
Add on the two outer rails. This time the stair support faces inwards.
Due to the stack up of part tolerances, you may need to sand this
part a little on the vertical edge as shown The part should sit onto the
floor easily. Notice also in the second image that the leg does not go
into the hole on the floor, but sits by the side. This is true for both the
lower and upper part. Check and recheck until happy then glue in
once more making sure it is vertical. allow these pieces to fully dry
before proceeding.