ii
SAFETY SUMMARY
The following safety precautions must be observed at all times during operation, service
and repair of this product. Failure to comply with these precautions, or with specific
warnings elsewhere in this manual, violates safety standards of design, manufacture, and
intended use of this product. Magnetic Instrumentation, Inc. assumes no liability for
failure to comply with these requirements.
GROUND THE EQUIPMENT
To minimize shock hazard, chassis, cabinets, and equipment racks must be connected to
an electrical ground. AC powered products are equipped with a three-connector power
cable, or equivalent connection on a terminal block. Power cables must be plugged into
an approved three-contact adapter with the grounding wire (green) firmly connected to an
electrical ground (safety ground) at the power outlet. The power jack and mating plug of
power cables provided meet International Electromechanical Commission (IEC) safety
standards. Equipment provided with terminal blocks, operating from either AC or DC is
provided with appropriate means for connecting an electrical safety ground.
DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE
Do not operate the product in the presence of flammable gases or fumes. Operation of
any electrical equipment in such an environment constitutes a definite safety hazard.
DO NOT OPERATE IN WET OR DAMP AREAS
Do not operate the product in wet or damp areas. Operation of any electrical equipment
in such an environment constitutes a definite safety hazard.
KEEP AWAY FROM LIVE CIRCUITS
Operating personnel must not remove covers. Replacement of components and internal
adjustments must be made by qualified maintenance persons. Disconnect power cable
when replacing components. Under certain conditions, dangerous voltages may exist
even with the power cable disconnected. To avoid injuries always disconnect power and
discharge circuits by grounding before touching them.
Summary of Contents for 942B
Page 2: ......
Page 25: ...18 NOTES...
