Magnetic Autocontrol MHTM, Operating Instructions Manual

Page: 86 / 132

Barrier MHTM
TM
MicroDrive Access and Parking
Electrical connection
86 5815,5001EN / Version 05
Hot surfaces
CAUTION
Danger of burns!
The motor surface may be hot. Touching this hot
surface can lead to burns.
– Do not touch these hot surfaces.
– After switching off the power supply wait some
minutes until the motor has cooled down.
– Wear protective gloves if necessary.
Electromagnetic interference
NOTICE
Electromagnetic interferences may cause
malfunctions of the barrier or adjacent devices!
The barrier is approved for industrial, residential,
commercial a business use. Operation in other
electro-magnetic environmental conditions may
cause interferences or malfunctions.
– Place control lines and mains cables into
separate conduits
– Use cables according to the electrical circuit
plan.
– Only install and apply additional parts approved
by MAGNETIC.
– The electrical and electronically additional parts
must be EMC verified and must not exceed the
indicated EMC limit values.
Personal protective equipment The following must be worn during all installation work:
 Work clothes
 Protective gloves
 Safety shoes
 Protective helmet.
9.2 Installing electrical protective devices
The safety installations that are required according to regional and
local regulations must be provided by the customer. Usually these
are:
 Residual current device (RCD)
 Circuit-breaker
 Lockable 2-pole main switch acc. to EN 60947-3.