Magnetic Autocontrol MHTM, Operating Instructions Manual

Page: 61 / 132

Barrier MHTM
TM
MicroDrive Access and Parking
Assembly and installation
5815,5001EN / Version 05 61
8.5 Unpacking
The individual packages are packed according to the expected
transport conditions. Only environment-friendly materials have
been used for the packaging.
The packaging should protect the individual components against
transport damages, corrosion, etc up to the assembly. Therefore
do not destroy the packaging and remove only directly before
assembly.
1. Unpack barrier.
2. Set up barrier housing vertically.
3. Lay down barrier boom.
4. Unpack and lay out accessories.
5. Separate material according to type and size and recycle
them after use.
8.6 Open barrier housing
Drive system, balancing springs, connection terminals and control
are protected with a hood and two doors. In most cases, it is
sufficient to remove the hood and the door facing to the road.
Hood and door facing the road 1. Unlock lock at the door facing the road.
2. Lift hood upwards. For this, push the hood back and lift it from
the two disconnections.
3. Pull out the door upwards.
Door facing away from the road 4. Loosen and remove the two hexagon screws with hexagon
socket.
5. Pull out the door upwards.
After any work 6. Install doors.
7. Attach and lock the hood.