![background image](http://html1.mh-extra.com/html/magnetek/enrange-mltx/enrange-mltx_instruction-manual_3585893008.webp)
Enrange Pre-Engineered MLTX Transmitter Instruction Manual
February 2011
Page 8 of 20
lift or carry any loads over people
operate the crane, hoist or lifting device unless all persons, including the operator, are and remain
clear of the supported load and any potential pinch points
operate a crane, hoist or lifting device when the device is not centered over the load
operate a crane, hoist or lifting device if the chain or wire rope is not seated properly in the
sprockets, drum or sheave
operate any damaged or malfunctioning crane, hoist, lifting device or other material handling
equipment
change any settings or controls without authorization and proper training
remove or obscure any warning or safety labels or tags
leave any load unattended while lifted
leave power on the radio controlled equipment when the equipment is not in operation
operate any material handling equipment using a damaged controller because the unit may be
unsafe
operate manual motions with other than manual power
operate radio controlled equipment when low battery indicator is on
1.5: TRANSMITTER UNIT
Transmitter switches should never be mechanically blocked ON or OFF. When not in use, the operator
should turn the transmitter OFF. A secure storage space should be provided for the transmitter unit, and the
transmitter unit should always be placed there when not in use. This precaution will help prevent
unauthorized people from operating the material handling equipment.
Spare transmitters should be stored in a secure storage space and only removed from the storage space after
the current transmitter in use has been turned OFF, taken out of the service area and secured.
1.6: PRE-OPERATION TEST
At the start of each work shift, or when a new operator takes control of the equipment, operators should do,
as a minimum, the following steps before making lifts with any equipment:
Test all warning devices.
Test all direction and speed controls.
Test the transmitter emergency stop.