Enrange Pre-Engineered MLTX Transmitter Instruction Manual
February 2011
Page 16 of 20
2.23: REPROGRAMMING THE PART 15 TRANSMITTER SYNTHESIZER
The Part 15 RF Transmitter can be reprogrammed by
removing the CPU board form the bottom housing.
Locate rotary switches on the RF Transmitter
Board (see Figure 3 MLTX Synthesizer Board).
The rotary switch nearest the corner of the
board is the ones place value selection (0-9).
The rotary switch more to the middle of the
board is the tens place value selection
(10, 20 and 30).
Figure 3 MLTX Synthesizer Board
Tens Ones
AK 20 would be 2 0
Compliance Statement (Part 15.19)
This device complies with Part 15 of FCC rules.
Operation is subject to the following two
conditions:
1.
This device may not cause harmful
interference, and
2.
This device must accept any
interference received, including
interference that may cause undesired
operation.
Warning (Part 15.21)
Changes or modifications not expressly
approved by the party responsible for
compliance should void the user’s authority
to operate the equipment.
This portable transmitter with its antenna
complies with FCC’s RF exposure limits for
general population/uncontrolled exposure.
Industry Canada Statement per Section 4.0 of RSP-100
The term "
IC:
" before the certification / registration number only signifies
that the Industry Canada technical specifications were met.
Section 7.1.5 of RSS-GEN
Operation is subject to the following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received,
including interference that may cause undesired operation.
Section 2.6 of RSS-102
This portable transmitter with its antenna complies with Industry Canada RF
Exposure Limits for General Population / Uncontrolled Exposure.
